0 of 0
About this mod
A bridge which can be imported into your own seed
- Requirements
- Permissions and credits
The bridge is approx 78x15 in LxW, and is tall enough for longship to pass under (high-tide/waves may cause issues).
The gap between the pillars leaves very little room on either side of the longship. I would advise building guidance beams to stop the ship getting stuck.
You will need to extend the support pillars if the bridge goes over water or a trench.
If the pillars aren't touching the ground, the top part will collapse.
On my seed, the pillars go down a further 3-4ish 1x2 stone walls deep, I am unsure if any further would cause structure issues.
I would recommend bringing up the terrain to meet if possible.
For sure there are some parts that don't line up perfectly. This was built on the fly with zero advance planning. Enjoy and adapt as you wish, I won't be updating this personally.
The gap between the pillars leaves very little room on either side of the longship. I would advise building guidance beams to stop the ship getting stuck.
You will need to extend the support pillars if the bridge goes over water or a trench.
If the pillars aren't touching the ground, the top part will collapse.
On my seed, the pillars go down a further 3-4ish 1x2 stone walls deep, I am unsure if any further would cause structure issues.
I would recommend bringing up the terrain to meet if possible.
For sure there are some parts that don't line up perfectly. This was built on the fly with zero advance planning. Enjoy and adapt as you wish, I won't be updating this personally.