I get this: When opening CK from steam it could load for a second and quit immediatly.
when installing CK from Steam, it creates a separete folder named Skyrim, so under common folder I have Skyrim (CK) and Skyrim Special Edition. I have paste the dll into the skyrim folder but i still get the load and quit if I launch CK from Steam. If I try to open de CK.exe i get procedure entry point SteamUGC could not be located in the dynamic link library.
I have been reading several post trying to fix this, I hoped this dll would allow me to open CK again but sadly it didn´t work. If anyone can give any other tip I would appreciate it
yeah I remember it used to do that, but not anymore it seems, and it only let me choose the disc for installation but not a specific directory. I will try again to copy and paste in the SE directory and then paste the dll
EDIT. Nothing it still gives me this error: CreationKit.exe - Entry Point Not Found
The procedure entry point SteamUGC could not be located in the dynamic link library H:\Steam W10\steamapps\common\Skyrim Special
Should probably mention this is mostly relevant to non-Steam Skyrim installs. If you are using the new CK with an older Skyrim Steam install, you need *both* this and the old dll, and have to swap between them or you will make Skyrim itself unable to load.
Yeah, basically everyone who owns Skyrim on something else than Steam is fucked, because this dll is a part of the Steam Skyrim installation, but not the CK.
10 comments
when installing CK from Steam, it creates a separete folder named Skyrim, so under common folder I have Skyrim (CK) and Skyrim Special Edition.
I have paste the dll into the skyrim folder but i still get the load and quit if I launch CK from Steam.
If I try to open de CK.exe i get procedure entry point SteamUGC could not be located in the dynamic link library.
I have been reading several post trying to fix this, I hoped this dll would allow me to open CK again but sadly it didn´t work.
If anyone can give any other tip I would appreciate it
EDIT. Nothing it still gives me this error:
CreationKit.exe - Entry Point Not Found
The procedure entry point SteamUGC could not be located in the dynamic link library H:\Steam
W10\steamapps\common\Skyrim Special