Replace the Statue of Loram Waterblade with a high poly one
Permissions and credits
Credits and distribution permission
Other user's assetsAll the assets in this file belong to the author, or are from free-to-use modder's resources
Upload permissionYou are not allowed to upload this file to other sites under any circumstances
Modification permissionYou must get permission from me before you are allowed to modify my files to improve it
Conversion permissionYou are not allowed to convert this file to work on other games under any circumstances
Asset use permissionYou must get permission from me before you are allowed to use any of the assets in this file
Asset use permission in mods/files that are being soldYou are not allowed to use assets from this file in any mods/files that are being sold, for money, on Steam Workshop or other platforms
Asset use permission in mods/files that earn donation pointsYou are not allowed to earn Donation Points for your mods if they use my assets
Author notes
"Hl. Wenzeslaus" (https://skfb.ly/oCvGU) by noe-3d.at is licensed under Creative Commons Attribution-NonCommercial (http://creativecommons.org/licenses/by-nc/4.0/).
File credits
This author has not credited anyone else in this file
Donation Points system
Please log in to find out whether this mod is receiving Donation Points
Changelogs
Version 1.2a
reduced polygons to 28.000, much better normal map
Version 1.2
added new textures of the base for the CM version
Version 1.1
added complex material for statue
Version 1.0
Initial release
Hello everyone, after spending countless hours trying to upscale the texture of the statue with no success and always getting poor results, I have decided to replace the model of the statue.
The replacement statue depicts the same subject as the original (St. Wenceslas), only in a slightly different pose, and is much more detailed. I found it on sketchfab and portet it to Skyrims Nif Format. The Polycount is about 40000. Since I have no great experience with meshes and such, this is unfortunately the least I could do without it looking bad.
Consequently, it might cause performance issues due to the mesh. Just to warn you, I haven't noticed any problems myself.
Complex Material Version: Complex Material is activated in the statue but not in the base. If you have installed the corresponding CM textures (Skyhaven, Falmerrosettastone), you can run Parallaxgen over it and patch the remaining Mesh for CM.
I hope you like it :)
"Hl. Wenzeslaus" (https://skfb.ly/oCvGU) by noe-3d.at is licensed under Creative Commons Attribution-NonCommercial (http://creativecommons.org/licenses/by-nc/4.0/).