This page was last updated on 25 December 2024, 12:52AM
Changelogs
Version 1.3.0
Improved Water handling to use full available range
Version 1.2.0
Compatibility with B99
Save State
Version 1.1.0
Improved Fire Handling logic to allow for more aggressive firing and still not over firing
Improved water handling to reduce chances of exposing crownsheet
New - Pulls parameters from boiler definition instead of hardcoded parameters.
New - Dismissable Fireman - Fireman can be dismissed with the radio
Optional Auto Add Fireman - Setting to control how fireman is added, can be set to not automatically add fireman
Fire Modes - Added 3 levels of firing logic progressively more aggressive about maintaining high pressure. Higher modes can overfire more easily
Added temperature rate and acceleration as well as pressure rate and acceleration information to fireman process to help determine whether to add fuel
Version 1.0.2
Rebuild for B98
Version 1.0.1
Fix bug which could cause you to lose all coal when paused
Fix bug which can cause you to not add firemen to other locos in the train if you use the comm radio to add the first one
Refined coal behavior to reduce waste hopefully without sacrificing performance
Version 1.0.0
Added Coal Handling
Added Configuration for Coal and Blower/Damper handling
Added Comm Radio mode to enable/disable adding coal
Allowed Comm Radio mode to summon a fireman if none present
Added Cylinder Cock handling - *default off*
Added slope awareness to water logic
Refined water logic to make it harder to fully run out
Added monitor of tender water level which prevents automatic adding of coal when water is low.
Added ability to manually engage injector when the fire is out and water is below the minimum to start the fire
Added logic for coal handling to first ensure minimum water is met before adding coal and/or starting the fire.
Version 0.1.0
Added more advanced water management (See Readme for details)
Added option to change assist levels, Over/Under will behave nearly identical to previous version, for those who just want safety, but want to mostly manage water themselves
Added override option - defaults to Temporary which will allow you to change the injector but will eventually change it again. See Readme for more information
Version 0.0.2
Enabled activation on startup if you are already in a supported loco
Enabled activation for supported locos in the same train and in future trains connected to an enabled loco
