This page was last updated on 06 July 2022, 6:03AM
Changelogs
Version 0.5.0
Wheel-to-rail adhesion now changes over space and time.
Integrate with Procedural Sky to decrease adhesion in wet conditions.
Add message when running through a junction damages it.
Add settings for variable adhesion and broken junction notifications.
Version 0.4.3
Fix traction curve on CCL locomotives.
Version 0.4.2
Remove Hasler speedometer simulation from SH282.
Stop speedometer ticking when locomotive is stationary.
Fix DE6s spawned before the mod is installed charging fees for sand refill.
Version 0.4.1
Fix broken speedometers.
Version 0.4.0
Separate custom couplers into a new mod. (https://www.nexusmods.com/derailvalley/mods/368)
Version 0.3.2
Add Hasler speedometer simulation.
Fix handcar interaction when rerailing or summoning.
Fix a case where couplers could loosen or tighten on their own.
Version 0.3.1
Update for Derail Valley r92.
Version 0.3.0
Enable custom couplers by default.
Add option for pulling cars with loose coupler chains.
Improve calculation of adhesion loss on a slope.
Adjust DE6 power and fuel consumption to match GP10 data.
Add HUD display for fuel consumption.
Fix DE2/6 consuming small amounts of oil when the engine is off.
Adjust default buffer damper settings.
Version 0.2.7
Fix crash when re-railing a car with custom couplers enabled.
Slightly increase lateral slack in chain buffer for custom couplers.
Version 0.2.6
Fix cars with only one coupler (steam loco and tender).
Version 0.2.5
Performance improvements for custom couplers.
Version 0.2.4
Fix pre-coupling joints not getting destroyed when cars despawn, causing physics bugs and explosions when the cars are respawned.
Fix the custom couplers setting being broken.
The custom couplers setting only takes effect on game restart.
Change sound effect when junctions break due to running through.
Version 0.2.3
Speedometer reflects wheel speed when wheels are slipping.
Buffers act to cushion car impacts before coupling.
Prevent couplers from breaking instantly when settings are being adjusted in realtime.
Version 0.2.2
Broken junctions toggle at random when run over as intended.
Adjust default buffer springs to match EU specifications.
Version 0.2.1
Add smoothing to fix couplers breaking in compression or because of spikes in physics simulation.
Add integration for Heads Up Display to show coupler forces.
Set default coupler strength to a realistic value.
Version 0.2.0
Feature: Optional custom couplers that should resolve derailing issues around tight bends. EXPERIMENTAL and may cause unpredictable physics problems. Back up your save before turning on the option in the mod UI.
Feature: Damage junctions by running through them.
Add automatic operation for the DE2 cooling fan. You can use the switch to force the fan to run all the time.
Add sound for the DE2 cooling fan.
Adjust fuel and oil consumption.
Make sander capacities and consumption rates more realistic.
Invert direction of DE2/6 throttle levers. Pull back to accelerate, push forward to reduce.
