Borderlands Ultimate Mod
Version 1.3

SUPPORTS BORDERLANDS 1 AND BORDERLANDS 2. FULL SUPPORT FOR BORDERLANDS: THE PRE-SEQUEL IS COMING.

NOTES:
-All features are optional, if you just want the console, you can take just that
-Run the game once before you install, so the game can be set up (prerequisites) and the .ini files will be generated.
-On rare occasions if the installer is run too quickly after a previous install, it will make a small mistake in the
WillowGame\Config\DefaultInput.ini, this can be fixed by pushing "h" in the installer and choosing repair (3).
-To restore a backup of your config files, push "h" on the menu and select Restore config files (2)

WHAT IT CAN DO:
-Remove the Nvidia and 2k videos on startup, which makes the game start faster
-Remove the story introduction movies
-Switch to a new splash screen
-Remove unnecessary prerequisites, readmes, and Eulas (Saving about 140 MB)
-Create a backup of your current config files and restore them later
-Enable console commands to be executed in game by pushing the ~ (Tilde) key

AVAILABLE GAME COMMANDS:
CLS - Clears console
Exit - Quickly exits the game
FOV # - Set the FOV of the game
Gamma Value # - Set the Brightness of the game
Quit - Quickly exits the game
Say (Message) - Puts message in game chat
Setres (Horizontal #)x(Vertical #) - Sets the Game Resolution
Screenshot - Takes a screenshot
Shot - Takes a screenshot
Stat FPS - Shows FPS on screen
Toggle HUD - Toggles the HUD visibility

(There might be more, but I don't know them)

INSTALLATION:
1) Place Ultimate Folder and Installer.bat inside borderlands directory
Default Location: C:\Program Files (x86)\Steam\SteamApps\common\Borderlands\
2) Run Installer.bat
3)Push 1 and then ENTER to begin install. (Should be quick)
4)When the first part is complete, push any key to finish the installation and exit
Keep the installer.bat and Ultimate folder if you want to uninstall it in the future

WHAT "FULL INSTALL" DOES:
-Removes NVidia and 2k videos that play when you start the game
-Switches to a blue splash screen
-Removes unnecessary prerequisites, readmes, and Eulas (Saving about 140 MB)
-Creates a backup of your current config files so you can restore them later if you want
-Enables console commands to be executed in game by pushing the ~ (Tilde) key

CHANGELOG:
V 1.3
-Borderlands 2 Support!
-New Splash Screens to choose for Borderlands 2 installs
-Added detection for Borderlands: The Pre-Sequel! (May have support soon!)
V 1.2
-Some code changes to allow Borderlands 2 support soon!
-A few new error messages to be more specific
-The installer will tell you if you do not have required files. Just redownload Borderlands Ultimate Mod if you don't, silly!
-Minor improvements
V 1.1
-Added the Version to the installer menu, wouldn't want you to forget what version you have (:
-Added Custom Installations!
-Added ability to remove the story introduction movies in custom installation options
-Added ability to remove splash, keep original, or use red, blue, or green!
-Fixed up code to reduce errors and allow for easier custom installations
-Trimmed down jrepl, (by like 18 KB!)
-Added Help menu when typing h or help on the menu
-Added the ability to restore config files from the backup
-Added the ability to repair a small mistake by selecting repair in the help menu
-Added a few more error screens. Those are friendlier than crashes, right?
-Redesigned backup system so that it only backs up on first install, to overwrite a backup you can either delete it or
you can choose backup in the custom install options
V 1.0
-Initial Release

CREDITS:
Created by: CrunchyCat