Tried the mod and it seems it messes a lot with mining. Usually I can stand just above a copper deposit to get full damage, with this mod installed I need to be on the top most pixel of an ore, otherwise I'm not getting full hits.
Unfortunately mod installation is getting convoluted, with all the 3rd party mod libraries around. Does it go in a dedicated mod\ folder or does it go into the BepInEx plugins\ directory? If you could clarify that, and also in the description would be great, especially for new mod users.
The default value of 1 in this mod doesn't work very well with 1h swords it seems in mistland, I keep hitting only 1 target at a time when aiming normally at enemies slightly angled above or below, and it messes with magic aiming too.
I think a tweaked value of 0.7 to 0.8 could help, haven't tested it yet.
Yes you can aim very high up or down with pickaxes and axes but with how the sword swings through enemies when you look straight ahead and not hit them is a bit jarring.
What might be interesting is if someone makes a auto-aim mod that configures this value based on the target you are aiming at with your crosshair, to work with bows and melee...
So it does a line of sight check from your 'center' of camera where you are seeing to a target and selects a target you are aiming towards as your basis of the center point. Then it compares the Y axis difference from your character to the target and tries to measure the right offset based on the weapon you have equipped (some swing wildly vertically or diagonal, or even too high or too low sweeping).
There is already a accuracy cone for ranged weapons which causes spread anyways at long ranges, so for bows it's not a big deal at long ranges. It's mainly there for melee attacks so you can hit what you are aiming at without needing to estimate how much extreme camera angles you gotta look to make your character hit 'below' you or 'above' you.
when thinking about lethal slopes in valheim i thought of stamina and friction, not attack angle o.O but ok. "hmm, block strike and slide down the slope, or tank it and - oh im sliding anyway, 2 stamina points too short, gj, oh theres water below, aint that nice"-proceeds to get pincushioned by fulings while desperately trying to scamper out of the water. that ever happened to anyone? 100%.
Give Feedback
171 comments
(as of 24-September-2023)
Keep up the great work!
Cheers o/
I think a tweaked value of 0.7 to 0.8 could help, haven't tested it yet.
Yes you can aim very high up or down with pickaxes and axes but with how the sword swings through enemies when you look straight ahead and not hit them is a bit jarring.
What might be interesting is if someone makes a auto-aim mod that configures this value based on the target you are aiming at with your crosshair, to work with bows and melee...
So it does a line of sight check from your 'center' of camera where you are seeing to a target and selects a target you are aiming towards as your basis of the center point. Then it compares the Y axis difference from your character to the target and tries to measure the right offset based on the weapon you have equipped (some swing wildly vertically or diagonal, or even too high or too low sweeping).
There is already a accuracy cone for ranged weapons which causes spread anyways at long ranges, so for bows it's not a big deal at long ranges.
It's mainly there for melee attacks so you can hit what you are aiming at without needing to estimate how much extreme camera angles you gotta look to make your character hit 'below' you or 'above' you.
Issue: Character load screen loads with naked characters. When loaded, the screen spins uncontrollably.
They probably blatenly dont want to, Its a horrible design.
Thanks for fixing what they refuse to