About this mod
~ Wounds Healed - 1.1 | OBSE ~ Allowing your body to slowly recover from combat. When you are not in combat, your body will now slowly heal itself. The default regeneration rate is 0.0015, which means that if your base health is 100, you will restore 0.15 points/second, meaning that i
- Permissions and credits
~ Wounds Healed - 1.1 | OBSE ~
Allowing your body to slowly recover from combat.
When you are not in combat, your body will now slowly heal itself. The default regeneration rate is 0.0015, which means that if your base health is 100, you will restore 0.15 points/second, meaning that it will take approximately ten minutes to fully restore your health. You can customize the regeneration rate by opening the console and typing set HealingRate to x, where x is the new regeneration rate. I'd recommend keeping it as low as possible.
As of version 1.1, there are also two additional modes available. In mode #1, your health will only be restored up to 25% of the total amount, while mode #2 will only restore your health if it's above 25%. To change the mode, enter set HealingMode to x in the console, where x is either 0 (default), 1 or 2.
If you have any suggestions for improvements, please post them in the official discussion thread.
Allowing your body to slowly recover from combat.
When you are not in combat, your body will now slowly heal itself. The default regeneration rate is 0.0015, which means that if your base health is 100, you will restore 0.15 points/second, meaning that it will take approximately ten minutes to fully restore your health. You can customize the regeneration rate by opening the console and typing set HealingRate to x, where x is the new regeneration rate. I'd recommend keeping it as low as possible.
As of version 1.1, there are also two additional modes available. In mode #1, your health will only be restored up to 25% of the total amount, while mode #2 will only restore your health if it's above 25%. To change the mode, enter set HealingMode to x in the console, where x is either 0 (default), 1 or 2.
If you have any suggestions for improvements, please post them in the official discussion thread.